Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Washer-To-Dryer Stacking Foot Cup
A cheaper replacement for the OEM stacking kit: four of these cups go on top of a front-load washer, and each dryer leveling foot drops into a tapered cup (36 mm at the floor, 44 mm at the 12 mm rim), which fits any foot from about 25 to 42 mm across. Each 100 x 60 x 3 mm plate fixes down with two #8 sheet-metal screws through 4.6 mm slots and has a 27 x 4 mm slot for a 25 mm anti-tip strap. The cup walls stop the dryer from walking off the washer.
Washer Dryer Door Catch Receiver
A universal cabinet-side door catch for front-load washers and dryers whose original plastic striker receiver has cracked: two long compliant jaws with rolled pinch ribs grab the door's striker prong (5–8 mm thick, up to 8.6 mm wide at the funnel mouth) and a 2.6 mm M3 self-tapping set screw in the back wall sets seating depth so the door seal compresses right. 76 x 56 x 22 mm with a 5 mm mounting plate — one 4.5 mm M4 clearance hole and one 12.5 mm slot on 58 mm centres so it aligns to existing cabinet screws; print in ASA, ABS or PC-blend if it goes on a dryer.