Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
MIG Contact Tip Four-Gauge Lane Tray
A 104 x 92 x 16 mm bench tray for MIG welding consumables. It has four round-bottomed lanes, each 20 mm wide and 56 mm long, so you can keep .023, .030, .035 and .045 contact tips apart. The front edge has 1 to 4 notches to tell the lanes apart by touch. A back row of three 25 mm wells holds nozzles, gas diffusers and spare drive rolls. Nothing depends on a brand-specific tip size: tips simply lie in the lanes and you scoop them out.
EMT Tube Fishmouth Coping Marking Sleeves
This twin marking sleeve slides onto 3/4 in EMT (23.4 mm OD) or 1/2 in EMT (17.9 mm OD). Each saddle-cut top edge is the exact fishmouth for a 90° tee into a tube of the same size, so you trace it with a fine marker and grind or file to the line. M4 thumb screws in self-tap bosses hold each sleeve in place while you trace. The part is 70 mm long and 26 mm tall, which solves the problem of hand-laying-out tube copes for EMT carts, racks and canopy frames.
TIG Tungsten Four-Size Stepped Rack
This stepped bench rack holds 24 TIG tungsten electrodes upright, sharp end up, with 6 per size: 1.6 mm (1/16 in), 2.4 mm (3/32 in), 3.2 mm (1/8 in) and 4.0 mm (5/32 in). The holes are 2.2, 3.0, 3.8 and 4.6 mm, and dimples on each step mark the size. Ground tips stop knocking together in a drawer, and the size you need is easy to grab. The rack is 80 x 56 mm with steps from 30 to 48 mm high. It is hollow with ribs inside, and each electrode stands in a floor socket under its hole.