Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Wheelie Bin Pinch-Clamp Axle Bracket
This bolt-on pillow block gives a curbside wheelie bin a new mount for its steel wheel axle after the moulded snap-in mount cracks. Measure your axle first: the split 17 mm bore is meant to pinch about 15.5–17 mm axles, including the common 5/8 in (15.9 mm) size. One M5 pinch bolt with a captured nut tightens the bore. The 96 x 46 x 30 mm block mounts to the bin base with two M5/#10 bolts through 12 mm vertical slots, so you can line it up with the old axle position. Print it on its side so the wheel load runs along the layers, not across them.
Dual 625 Outboard Wheel Axle Block
A flanged bearing block that holds two 625 bearings (5 x 16 x 5 mm, press-fit 16.05 mm pockets, 21.6 mm apart) on a 5 mm wheel axle. It bolts to a chassis side plate with four M3 screws on a 32 mm square. It takes the wheel load off wobbly TT gearmotor output shafts and other small drive shafts: couple the motor to the 5 mm axle and let this 44 x 44 x 32 mm ribbed block carry the load.