Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Snow Shovel Bolt-On Wear Edge Strip
This is a 150 mm sacrificial U-channel. It slides over the worn edge of a plastic snow shovel blade up to 6 mm thick, and you bolt it on with three M5 bolts through 5.5 mm holes. The 8 mm solid wear pad has a 45° chamfered nose and takes the scraping on concrete instead of the blade. Print three and butt them end to end to cover a 450 mm blade.
Snowblower Sled-Runner Skid Shoe
A replacement skid shoe for a snowblower auger housing. It has a 130 mm sled runner, 22 mm wide and 7 mm thick, that turns up at both ends so it glides over gravel and pavement cracks instead of digging in. The two vertical adjustment slots are 9 mm wide, fit 5/16 in or M8 bolts, sit 70 mm apart by default and give 21 mm of height travel. Measure your old shoe's hole spacing and set BOLT_SPACING to match it.
Snow Shovel D-Grip Clamp Handle
A replacement D-grip for snow shovels and garden tools with a 1-1/8 in (28.6 mm) wood or fiberglass shaft. It has a 29.1 mm socket, 47 mm deep, with a split top that two M5x20 bolts and captured nuts pinch shut. A #8 wood screw goes up through the bottom into the shaft to stop it from twisting. The grip opening is 86 x 62 mm, big enough for a gloved hand, and it's printed flat so pushing and pulling loads run along the layers, not across them. For 1 in (25.4 mm) shafts, set BORE to 25.9.