Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Twin-Hook Shower Curtain Rod Hanger
An open J-hook that drops over any round shower curtain rod up to 32 mm (1-1/4 in) across and hangs the curtain from one hook and the liner from the other, so you can take the liner down to wash it without unhooking the curtain. The part is 62 x 72 x 7 mm and prints flat, so the load runs along the layers instead of pulling them apart. The rod opening is 35 mm wide and the rod sits in a 35 mm seat.
Shower Curtain Rod Socket Flange
A wall socket for a 25.4 mm (1 in) shower or closet curtain rod, with a 25 mm deep bore whose flared trumpet mouth lets the rod enter up to about 14 degrees off-square — the fix for sloped ceilings, bowed tile walls and out-of-plumb corners where a straight metal rod cup will not seat. 70 mm round flange, 34 mm tall, four M4 anchor holes on a 55 mm cross, an M4 self-tapping set screw through a 7.8 mm thick collar to lock the rod, and a 5 mm drain port opposite it so water runs out instead of pooling in the cup.