Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Glass Shelf Wall Clamp Bracket
A wall bracket that clamps a glass shelf (6–8 mm) over a bathroom sink. The jaw is 8.6 mm high, so it takes 8 mm glass on its own or 6 mm glass with a 2 mm rubber pad. An M4 thumb screw in a brass heat-set insert (5.5 mm bore) locks the glass in place. Two counterbored 4.8 mm holes take #8 screws at the top of the 30 mm wide × 62 mm tall plate, and the tapered lower jaw reaches 48 mm under the glass. It prints on its side, so the shelf load runs along the layers rather than across them.
Medicine Cabinet Glass Shelf Clip
Replacement side-wall channel clip that carries a 1/4 in (6 mm) glass shelf in an old steel or wood medicine cabinet, for when the original stamped clips are long discontinued. The 90 x 22 x 16 mm body has a 6.8 mm wide, 12 mm deep channel with a flared lead-in and a closed back stop, plus two 3.4 mm M3 clearance holes 70 mm apart on tabs clear of the jaws so a screwdriver reaches; the flat 4 mm back also takes VHB tape if you can't drill the cabinet. Symmetric about its centreline, so the same print flipped over serves the opposite wall — print two.