Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pedestal Sink Column Taper Shim Set
A snap-off sprue of four tapered shims (2, 3, 4 and 5 mm thick, each 16 mm wide with a 45 mm taper down to 0.8 mm) for a pedestal sink that rocks. The column rim rarely sits flush against the underside of the basin, so you tap a shim into the gap, trim it flush and caulk over it. Each shim has a 1-to-4 notch size code on its grip tab and cross-grooves on the sloped face so it doesn't slide back out.
Pedestal Sink Single-Lug Wall Hanger
A replacement for the discontinued steel hanger that holds a pedestal sink's back edge to the wall. You print two and screw each one wherever the sink's rear slots land, so any lug spacing works. Each one is 36 mm wide, 80 mm tall and stands 30 mm off the wall, with an 8 x 14 mm upright tab that the sink's slot drops onto. Two vertical 5.3 mm slots take #10 (4.8 mm) wood screws into blocking and give 10 mm of height adjustment. The hook is printed on its side, so the sink's weight never pulls across the layer lines.