Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1/2 in EMT Clawfoot Shower Rod Drop Tee
A set-screw tee for DIY clawfoot tub shower curtain rods made from 1/2 in EMT conduit (17.9 mm OD). The horizontal curtain rail passes straight through an 18.3 mm bore, and the vertical ceiling drop sits 30 mm deep in a top socket. Three M4 self-tapping set screws (3.4 mm pilots) lock both tubes. The body is 50 x 28 x 60 mm, and the rail bore has a teardrop top so it prints without supports.
PVC Towel Ladder Rung Tee Joint
A slip-fit tee joint for building a leaning bathroom towel or blanket ladder. It takes a 1" schedule 40 PVC side rail (33.4 mm OD, 33.8 mm bore) and a 3/4" rung (26.7 mm OD, 27.1 mm socket, 30 mm deep). The same part works on both rails. Each pipe is locked with a #6 wood screw into a 2.5 mm pilot hole, and the part prints without supports with the rail bore lying flat as a truncated teardrop.