Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1/2 in PVC Over-Tub Caddy End Saddle
This end saddle turns two lengths of 1/2 in schedule 40 PVC pipe (21.3 mm OD) into a bath caddy that sits across the tub, sized to any tub once you cut the pipe to length. Each saddle has two 21.7 mm slip-fit sockets 27 mm deep on 70 mm centres, an M3 cross-pin hole to lock each rail, an 18 mm drop lip that hooks inside the tub wall, and a 30 mm deep pad that rests on the rim. Print two; each one is 104 x 52 x 32 mm.
Swing-Out Towel Arm Hub For 1/2 in PVC
A wall-mounted swivel towel arm that prints in place with its hinge already assembled. It is a 52 x 52 mm wall plate with four 5 mm holes for #8 screws, and a 28 mm hub that turns on a 12 mm pin. The hub has a 21.6 mm socket, 32 mm deep, for 1/2 in schedule 40 PVC (21.3 mm OD) cut to any length, and a #6 screw hole pins the pipe in place. Cone-shaped bearing faces and 0.5 mm gaps let the hub swing about 90° either way, so a drying towel folds flat against the wall.
1 in PVC Spare Toilet Roll Tower Base
A freestanding 150 mm spoked base that holds 1 in Schedule 40 PVC pipe (33.4 mm OD) upright in a 40 mm deep slip-fit socket (33.9 mm bore). Stack spare toilet rolls on the pipe next to the toilet: cut the pipe to whatever height you want, with no drilling and no wall anchors. A drain hole in the socket floor lets mop water run out.
PVC Towel Ladder Rung Tee Joint
A slip-fit tee joint for building a leaning bathroom towel or blanket ladder. It takes a 1" schedule 40 PVC side rail (33.4 mm OD, 33.8 mm bore) and a 3/4" rung (26.7 mm OD, 27.1 mm socket, 30 mm deep). The same part works on both rails. Each pipe is locked with a #6 wood screw into a 2.5 mm pilot hole, and the part prints without supports with the rail bore lying flat as a truncated teardrop.
Twin 1/2 in PVC Supply Line Stud Clip
A snap-in stud clip that holds a hot and cold pair of 1/2" schedule 40 PVC lines (21.3 mm OD) side by side on 34 mm centres. It stands them about 16 mm off the stud or joist behind a vanity or tub during a bathroom repipe, so you don't need two separate straps. Two counterbored 4.6 mm holes take #8 wood screws or M4 screws. The clip is 96 x 30 x 16 mm, printed on its side so the pipe load sits in the layer plane.