Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Over-Toilet Tank Shelf Bracket Pair
A trussed wall bracket for a DIY shelf above the toilet tank. Print two and screw them into the wall on either side of the tank, then drop in any 19 mm (3/4 in) board up to 130 mm deep. A raised backstop tab and a 10 mm front lip hold the board in place, so you don't need a full over-toilet cabinet. Each bracket is 150 x 155 x 14 mm and is printed flat, so the shelf load runs along the layers instead of across them. It has 5.5 mm wall-screw holes above and below the arm for #8/#10 screws and two 4.5 mm holes for fixing the board from underneath.
Shower Curtain Rod Socket Flange
A wall socket for a 25.4 mm (1 in) shower or closet curtain rod, with a 25 mm deep bore whose flared trumpet mouth lets the rod enter up to about 14 degrees off-square — the fix for sloped ceilings, bowed tile walls and out-of-plumb corners where a straight metal rod cup will not seat. 70 mm round flange, 34 mm tall, four M4 anchor holes on a 55 mm cross, an M4 self-tapping set screw through a 7.8 mm thick collar to lock the rod, and a 5 mm drain port opposite it so water runs out instead of pooling in the cup.