Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Adhesive Shower Caddy Screw-Down Hook Plate
This screw-down plate replaces the failed adhesive hook on a wire or plastic shower caddy. It has a 12 mm top hook channel for the caddy's hanger loop or slot and an 8 mm bottom J-channel that catches a 3–7 mm back rail to stop swaying. It measures 50 x 90 mm with a 22 mm projection, fixes with four countersunk #8 or M4 screws (4.6 mm holes) into anchors or tile plugs, and prints on its side so the hook load runs along the layers instead of across them.
Fork-Cradle Shower Squeegee Wall Hanger
This screw-on wall hanger holds a shower squeegee on two forked arms. The handle drops through a 22 mm gap, and the blade sits in a 34 mm-deep cradle with a lip that stops it sliding off. It takes handles up to 22 mm thick. The part measures 45 x 70 x 46 mm and fixes to the wall with two #8 wood screws or M4 screws through 4.6 mm holes that are 50 mm apart. It prints on its side, so the arms carry the load along the layers and not across them.
Wall-Mount Hand Towel Hoop
A towel ring that sticks straight out from the wall. It has a D-shaped opening about 100 x 93 mm that you push a hand towel through. The backplate is 80 x 50 x 6 mm with two 5.5 mm holes 40 mm apart that take #8 or #10 pan-head screws or wall anchors. It prints flat on the hoop, so layer lines run along the arm that carries the load, and two side gussets and a centre gusset brace it against the wall plate.