Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1-1/4 in Grab Bar Snap-On Towel Hook
A snap-on J-hook that clips onto a standard 1-1/4 in (31.75 mm OD) shower or tub grab bar. It gives you a place to hang a loofah, washcloth or razor strap without drilling tile. The C-clip has a 32.2 mm bore and a 27 mm snap mouth and is printed flat, so the clip flexes in the strong layer plane. The part is 16 mm thick, about 83 mm tall and weighs about 12 cm³.
Snap-On Toilet Bolt Cap And Washer
A replacement toilet closet-bolt cover: a 34.6 mm dome cap, 37 mm tall, that snaps over a 28.8 mm retainer washer. The washer has an 8.5 mm bore for 1/4" and 5/16" closet bolts and sits under the nut. Both pieces print nested as one job, and the four flex fingers let the washer pop out for fitting.
Snap-In Sink Hole Cover Plug
A snap-in cover plug for the standard 1-3/8 in (34.9 mm) faucet or side-sprayer hole left open in a sink or countertop after a faucet swap. A 50 mm diameter flange hides the hole and six 45 degree ratchet fins on six flexing legs grip deck thicknesses from about 5 mm to 28 mm; overall 50 mm across and 33 mm tall, printed visible-face-down so the show face comes off the plate smooth.