Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Broken Recessed Soap Niche Bridge Tray
A tray that drops into the hole left when a cracked built-in ceramic soap dish is chiselled out. It has a 120 x 78 mm draining shelf that is 37 mm deep, and its 160 x 118 mm face flange covers broken tile edges around any opening from about 126 x 84 up to 155 x 113 mm. Flex fins on the sleeve centre it while you set it in silicone, and the shelf floor is flush with the flange so water runs straight out over the tile. You don't have to find a matching discontinued tile or retile the wall.
Tub Lip Screw-Clamp Draining Soap Ledge
A drill-free soap and razor ledge that clamps over the rim of a freestanding, clawfoot or drop-in tub. An M5 screw runs through a captured nut and closes on any rim from about 4 to 38 mm thick, with a 30 mm deep jaw. The 56 x 70 mm tray drains through twelve 4 mm holes, has a 15 mm front lip, and two gussets carry the load into the inner jaw. It prints flat on its side, so the clamp loads stay in the layer plane.
Faucet Base U-Wrap Drip Tray
A 150 x 100 x 10 mm horseshoe tray that slides in from the back around a single-hole faucet base up to 62 mm across. You don't have to take the faucet off to fit it. The splash and pump-bottle drips that run down the faucet stay in a 2 mm floor with drainage ribs, so the vanity top stays dry and a soap bar or toothbrush can sit on the ribs and dry out. A 3 mm collar sits around the faucet.
1-1/4 in Grab Bar Saddle Soap Dish
This soap dish snaps onto a standard 1-1/4 in (31.75 mm) shower grab bar, so you don't have to drill new holes in the tile. The clip has a 32.2 mm bore and wraps 240° around the bar at both ends. The ribbed 72 x 80 mm tray sits directly above the bar, so the soap's weight doesn't twist it. Six drain slots let water run straight down onto the bar.