Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
P-Clamp Eight-Spindle Sort Board
A 150 x 100 mm tray with eight 4 mm spindles that hold loose rubber-lined P-clamps by their screw eyes: the back row takes 16, 19, 22 and 25 mm clamps and the front row takes 6, 8, 10 and 13 mm. The back wall has eight U-notches cut to the same sizes. Drop a fuel line, coolant hose or harness into the notches to find its diameter, then take the matching clamp straight off its spindle.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.
Trailer Harness Three-Size Frame P-Clip Set
A set of three screw-down P-clips joined by snap-off sprues, with 8, 12 and 16 mm bores for trailer and small-equipment wiring harness bundles. Each clip prints flat as a 12 mm wide strap. The two tabs start 1.5 mm apart and a single 5.5 mm hole (#10 or M5 screw) runs through both, so tightening the screw against the frame rail closes the loop on the bundle. Use them to replace factory clips that went brittle.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.