Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Wire Shelf Post Grow-Light Arm Clamp
A pinch clamp that bolts onto a 1 in (25.4 mm) wire-shelving post and holds a 1/2 in EMT conduit arm (17.9 mm OD) sticking straight out, so you can hang LED grow bars or shop lights from it with S-hooks or chain instead of zip ties. Two M5 bolts close a 4 mm pinch slot, so it grips posts from about 24.9 to 26.2 mm. A third M5 bolt goes through the 38 mm deep socket and a hole you drill in the EMT, which stops the arm from twisting or sliding out. It measures 84 x 36 x 36 mm.
Push Broom Brace Socket For 3/4 in EMT
A screw-on 45° handle socket that turns a shop push broom with a snapped or stripped handle into one with a 3/4 in EMT conduit handle (23.4 mm OD; 23.8 mm bore, 57 mm deep). A ribbed 112 x 44 x 6 mm base fixes to the broom block with four #8 wood screws, and an M5 through-bolt across the socket locks the conduit in place.
Joist J-Hook For 3/4 in EMT Rail
This hanger screws flat to the side of an exposed ceiling joist and holds a 3/4 in EMT conduit tube (23.4 mm OD, 24.2 mm seat) in a drop-in J-hook about 70 mm below the joist. Mount one on every joist to run cheap conduit rails for overhead garage storage. It prints flat, so the tube's weight pulls in the plane of the layers, and the three 5.5 mm holes take #10 washer-head screws loaded in shear. A pair of zip-tie holes lets you strap the tube in so it can't lift out.
PVC And EMT Offcut Socket Wall Rack
This wall rack has five upright sockets that keep short pipe offcuts sorted by size: 1 in (33.4 mm OD), 3/4 in (26.7 mm) and 1/2 in (21.3 mm) schedule 40 PVC, plus 3/4 in (23.4 mm) and 1/2 in (17.9 mm) EMT conduit. Each 36 mm deep socket is 1.5 mm over the pipe's OD and has a drain hole in the floor. The 156 x 52 mm back plate takes two #8 wood screws.
Dual Size EMT Conduit Snap Hanger
A screw-down wall plate with two snap-in saddles that take 3/4 in EMT (23.4 mm OD, 23.7 mm bore) and 1/2 in EMT (17.9 mm OD, 18.2 mm bore), so a conduit and a small pipe or hose run stacked on one anchor point. Overall 102 x 26 x 25.5 mm; two 4.5 mm holes 84 mm apart take M4 or #8 wood screws, the lips wrap past the pipe centreline for a 0.5 mm one-hand snap, and a dovetail tongue and socket on the ends let hangers gang into a continuous run along a wall or joist.