Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
CB Palm Mic Flex-Fin Dash Cradle
This is a universal holster for CB and ham radio palm mics. Six angled flex fins grip mic bodies from 54 to 68 mm wide and up to 38 mm thick, and the cord exits through an 18 mm notch at the bottom. It's meant for drivers whose dash has no place for the stock hanger clip. The cradle measures 104 x 85 x 50 mm and mounts with two or four #8 screws through 4.6 x 10 mm slots. It prints flat on its back, so the springs bend in the layer plane and the mic's weight pulls in XY, not across the layer lines.
Flexure Hose Pinch-Off Clamp M5
This one-piece flexure clamp pinches a coolant, fuel or vacuum hose shut while you swap a hose clamp or a part. The two smooth jaws are 8 x 14 mm and have 88 mm of usable length, enough for hoses up to about 45 mm OD laid flat. One M5 x 40 bolt runs through 5.5 mm holes and threads into a captured M5 hex nut pocket to close the 10 mm jaw gap, and a 2.5 mm living-hinge loop opens the jaws again when you loosen the bolt.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.