Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Knock-Down 2x4 Sawhorse Bracket
This sawhorse head holds a 2x4 top beam on edge (38 x 89 mm actual) in a 38.8 mm channel. Two 38.8 mm leg sockets splay 15° to each side for 2x4 legs. Each wall has 4.8 mm clearance holes for #8 wood screws, so you can build folding shop sawhorses from scrap lumber. The part is about 125 x 106 x 30 mm and is printed flat, so the beam load goes into the legs along the layers rather than across them. Use two per horse.
Plywood Panel Carrier Handle
A one-piece sheet-goods carrier that hooks under the bottom edge of plywood, MDF or drywall so you can move a full sheet single-handed. The self-centring V cradle takes panels 6–22 mm thick (1/4" to 7/8"), carrying the load in bearing on a 12 mm land rather than friction, and the offset 24 mm spine clears the panel face. 136 x 156 x 14 mm, printed flat so every load path runs in the layer plane; scalloped 16 mm grip bar with chamfered corners, plus an 8 mm hole to hang it on a nail.