Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Slotted J-Bolt Battery Hold-Down Bar
A ribbed top bar that clamps a 12 V battery into its tray using the tray's two existing M6 or 1/4 in J-bolts. It replaces the snapped or corroded OEM hold-down. The bar is 170 × 28 mm with ribs 17 mm tall. The 6.8 mm slots at each end take any bolt spacing from 110 to 160 mm, which covers the U1 mower and garden-tractor batteries and the small ATV and motorcycle batteries whose trays leave them rattling. For engine-bay heat, order it in PETG or ASA.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
Mower Wheel Axle Bushing Set
A snap-apart run of three split flanged sleeve bushings for worn mower, wheelbarrow, snowblower and hand-truck wheels — bores of 13.1, 16.3 and 19.5 mm for 1/2", 5/8" and 3/4" axles (12.7 / 15.88 / 19.05 mm), each 25 mm long with a 2.5 mm thrust flange (25.0 / 28.2 / 31.4 mm flange dia). Bodies are 19.0 / 22.2 / 25.4 mm OD with six crush ribs taking them to 21.0 / 24.2 / 27.4 mm, so one bushing presses into any hub bore across that range; a 2.4 mm axial split lets it spring onto the axle and pinch down into an undersize bore, and two internal grease channels keep it fed. Snip the 1.2 mm webs with side cutters and use the size you need — the whole card is 95 x 31 x 27.5 mm.