Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
3 in Mower Deck Anti-Scalp Roller
This replaces the plastic anti-scalp roller on a mower deck: a crowned roller 76 mm (3 in) across and 38 mm wide with a 10.0 mm plain bore that turns on a standard 3/8 in (9.5 mm) shoulder bolt. The hub stands 2 mm proud of the rim on one side so the rim never rubs the deck bracket. Six ribs and drain holes keep it light at about 60 cm³, so grass clippings and water don't pack inside. Before you order, measure your old roller's diameter, width and bolt size.
Screw-Through Cargo Tie-Down Hook
A screw-on J-hook that replaces a snapped cargo-net or tie-down hook in an SUV, wagon or trailer. It has a 70 x 16 mm base flange with two M4 / #8 clearance holes (4.5 mm) on 50 mm centres, and a 15 mm entry throat that takes net loops, bungee hooks and strap hooks. It prints on its side, so the pull from the strap runs along the layers instead of across them.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Bolt-On Ladder Rail Foot Cap
Replacement foot cap for aluminium step and extension ladders with 40 x 20 mm rectangular leg tubing — it slips over the rail end (40.6 x 20.6 mm socket, 27 mm deep) and is held by an M5 bolt through the rail instead of glue, with two 5.5 mm hole heights (14 mm and 24 mm above the ground) so you can reuse the original rivet hole. The 52 x 32 x 7 mm pad has 3 mm deep tread grooves and a 5 mm centre drain, total height 34 mm.