Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1/2, 3/4, 1 in Knockout Blank Plug Set
A set of three snap-in blanking plugs for unused electrical knockouts: 1/2 in trade (22.2 mm hole), 3/4 in trade (27.8 mm) and 1 in trade (34.5 mm). They print on one snap-off sprue about 121 mm long. Slotted spring fingers with a 45° barb push in from the front, grip steel box and panel walls about 1–2 mm thick, and leave a flush flange 4 mm wider than the hole on every side.
6/8 mm Hood Prop Rod Snap Clip
A replacement retaining clip for a car hood prop rod. It screws flat to the hood inner panel or radiator support with three M4 or #8 screws (4.5 mm holes, 29 mm apart) and has snap-in jaws for 6 mm and 8 mm rods. The bores are 6.3 and 8.3 mm with a mouth 1 mm narrower than the rod and a flared lead-in. The body is 70 x 14 mm and fixes the rattling, loose prop rod you get after the original clip breaks.
Dual Size EMT Conduit Snap Hanger
A screw-down wall plate with two snap-in saddles that take 3/4 in EMT (23.4 mm OD, 23.7 mm bore) and 1/2 in EMT (17.9 mm OD, 18.2 mm bore), so a conduit and a small pipe or hose run stacked on one anchor point. Overall 102 x 26 x 25.5 mm; two 4.5 mm holes 84 mm apart take M4 or #8 wood screws, the lips wrap past the pipe centreline for a 0.5 mm one-hand snap, and a dovetail tongue and socket on the ends let hangers gang into a continuous run along a wall or joist.