Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Trimmer Line Spool Wall Peg With Eyelet
This wall plate (60 x 120 mm, about 82 mm deep) holds a donut or spool of string trimmer line with a centre hole of 38 mm or more. A cross-ribbed peg 78 mm long has a 4 mm hook-up tip that stops the spool sliding off. Below the peg, a 4 mm eyelet feeds line of 1.6–2.7 mm (0.065–0.105 in), and a 1.4 mm pinch kerf in the bottom edge holds the loose end so the coil doesn't unwind. It mounts with four 5.5 mm holes for #8/#10 wood screws or M5 bolts.
608 Bearing Wire Spool Dispenser
A bench- or wall-mounted spool cradle that lets MIG wire, tie wire, solder, string or trimmer line pay out freely instead of binding. Two 608 bearings (8x22x7) press into stepped 22.05 mm seats with a 16 mm retaining lip, and an M8 x 130 mm bolt serves as the axle; the 128 x 54 x 5 mm base screws down through four M5 clearance holes on a 110 x 37 mm pattern. Bore axis sits 52 mm up for roughly 90 mm of spool diameter, with 75 mm of clear width between the uprights.