Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Trailer Fender Slotted Mud Flap Bracket
A 50 mm wide L-bracket with a corner gusset that bolts under a utility-trailer fender and holds a mud flap. Its 52 mm fender leg has 18 mm adjustment slots for M5 bolts, so it fits a range of fender lip positions without new drilling. The 70 mm drop leg has three 18 mm height-adjust slots plus a fixed 5.5 mm M5 hole to hang the flap.
Tongue Jack Flex-Fin Ground Foot Shoe
A 100 mm wide replacement ground shoe for trailer tongue jacks with a cracked or missing plastic foot. Eight angled flex fins inside a 56 mm socket grip round jack feet or inner tubes from 44 to 52 mm. Eight gussets carry the load into the base, there is an 8 mm drain hole, and four 5.5 mm holes let you lag-screw or stake it to a plywood pad.
2 in Hitch Ball Mount Wall Socket
Wall-mounted open-top square socket that stores a standard 2 in receiver hitch ball mount by its shank, so the drawbar stops kicking around the garage floor. The socket is 52.5 mm square inside and 70 mm deep, with 16.6 mm slots in both side walls so the 5/8 in hitch pin and clip pass through the shank's pin hole and lock the mount in place; the 92 x 100 mm back plate takes three #10 wood screws through 5.5 mm holes into a stud.
Trailer Harness Three-Size Frame P-Clip Set
A set of three screw-down P-clips joined by snap-off sprues, with 8, 12 and 16 mm bores for trailer and small-equipment wiring harness bundles. Each clip prints flat as a 12 mm wide strap. The two tabs start 1.5 mm apart and a single 5.5 mm hole (#10 or M5 screw) runs through both, so tightening the screw against the frame rail closes the loop on the bundle. Use them to replace factory clips that went brittle.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Hitch And Clevis Pin Sorting Rack
A 150 x 54 mm bench rack for trailer, mower and farm-equipment pins. It has five size-stepped sockets for 1/4, 5/16, 3/8, 1/2 and 5/8 in (6.35–15.9 mm) clevis and hitch pins, with bores 0.65 mm oversize at 7.0 to 16.5 mm. Each socket is marked with 1 to 5 dimples. A front tray with three bays holds cotter pins, R-clips and linch pins, so they stop tangling in one bin.
Trailer And Mower Wheel Chock
A truss-built wheel chock, 130 mm long x 66 mm tall x 34 mm wide, with a concave tire cradle face and eleven sawtooth cleats on the ground face to bite into concrete or asphalt. Sized for trailer, mower, ATV, handcart and shop-dolly tires; it prints profile-down so every wall is vertical and the compression load runs along the layer lines rather than across them. The open truss windows double as a finger grip for pulling it out from under a tire. Not a substitute for jack stands.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.