Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
M3 Screw-Ear Small Tubing Clamp Trio
A set of three split-ring clamps for small tubing, with 6.5, 9 and 11 mm bores, joined on a snap-off sprue bar. Each one closes with an M3 bolt through a 3.4 mm clearance hole into a captured M3 nut pocket (5.7 mm across flats), so you can squeeze silicone, vinyl or air-line tubing tight onto barbs without hunting for tiny worm-drive clips.
Clamp-On Hair Dryer Concentrator Nozzle
Replacement concentrator nozzle for a hair dryer or heat gun with a round barrel of about 52–56 mm, which replaces a lost or cracked OEM snap-on. The 54 mm slotted collet sleeve is tightened by a hose clamp or zip tie in the recessed band seat, and it narrows the airflow to a 66 x 9 mm oval slot about 80 mm from the barrel.
Washer Drain Hose Standpipe Clamp
A split collar that clamps onto a 2 in Schedule 40 PVC laundry standpipe (60.3 mm OD) with one M3 x 30 screw and a captured M3 nut, plus a snap-in C-jaw that grips the washer's corrugated drain hose (30–35 mm OD) so it can't kick out of the pipe and flood the room. 113 x 68 x 22 mm, prints flat with no supports and no overhangs.