Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Aquarium Rim Clamp Hose Saddle
A screw-adjustable clamp that hooks over an aquarium rim or bare glass up to 18 mm thick and carries a 90° saddle trough for a filter hose, heater cord, CO2 line or probe cable, with a 3.5 x 8 mm zip-tie slot under the trough to lock the line down. Overall 64 x 37 x 25 mm; tightens with an M4 x 30 screw into an M4 heat-set insert (5.5 mm bore) in the outer jaw, so it fits rimless tanks, trimmed tanks and sump baffles without a single guessed dimension.
Register Vent Air Deflector Clamp
A 150 mm wide, 50°-angled deflector blade that screw-clamps onto the outermost louver fin of a floor, wall or ceiling HVAC register to throw supply air away from curtains, a bed or a sofa instead of straight up the wall. Two clamp posts take an M4 heat-set insert (5.5 mm bore) and an M4 set screw that pins any fin up to 12 mm thick against an 8 mm anvil, so it works on stamped steel and moulded plastic registers alike — unlike magnetic deflectors that slide off. Blade is 2.6 mm thick with three full-length stiffening fences; overall 150 x 69 x 66 mm, prints rail-down with no supports.