Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Sink Plug Parking Peg With Chain Notch
A wall-screwed peg that holds a loose sink or bath plug off the basin. The 25 mm peg with its 18 mm up-turned lip holds the plug, and a 3 mm notch in the lip catches the bead chain. The 30 x 75 mm plate takes two 4.5 mm countersunk holes for #6/#8 wood screws or M4, and a 45° rib under the peg carries the load across the layers.
Ironing Board Twin-Hook Wall Hanger
A wall hanger for a folding ironing board: it screws to the wall and has two gusseted J-hooks, 100 mm apart overall, that catch the board's folded leg crossbar. Each hook has a 35 mm deep throat and an 18 mm lip, so leg tubes up to about 30 mm fit. It prints on its side, so the weight pulls along the layers instead of peeling them apart. Three 4.5 mm holes take #8 wood screws or M4 bolts.
Screw-On Curtain Tieback Holdback Hook
A curtain holdback that screws to the wall or window trim. Two #8 wood screws (4.2 mm shank) go through 4.6 mm clearance holes, 48 mm apart, with 8.5 mm counterbores for pan heads. A 51 mm deep cradle with an 18 mm lip holds a gathered drape open. The hook stands 64 mm tall, reaches 65 mm from the wall and is 16 mm wide. It prints on its side, so the curtain's weight runs along the layers instead of peeling them apart, and a gusset under the arm stops it drooping.