Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Piping Tip Cone-Peg Drying Rack
A 110 x 144 mm tray with 12 hollow tapered pegs that hold decorating piping tips upright while they dry and while they're stored. Each peg tapers from 24 mm to 8 mm over 32 mm, so tips of any brand or size slide down until they seat, and water drains through the open peg onto the counter.
Three-Tier Cooling Rack Corner Tower
This is a corner tower. Print four of them and you can stack three wire cooling racks of any rectangular size above the counter, with 48 mm between levels. Each tower is an L-shaped post 154 mm tall with 50 mm arms and 10 mm ledges supported on 45° gussets. A wide L-shaped foot keeps it steady, and the walls on the outer sides stop the racks from sliding off.
Two-Tier Rolling Pin Wall Cradle
A wall bracket with two 90° V-cradles, 168 mm tall and 70 mm deep, that holds two rolling pins between 25 and 65 mm in diameter. Mount a pair about 250 mm apart with #8 wood screws or M4 screws through the 4.6 mm holes. Pins of any shape can go in, including straight, tapered French and handled pins. It prints on its side, so the pin's weight bends the arms along the layers rather than prying the layers apart.