Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
2x4 Stud Saddle Marker Caddy
A four-cell bin that sits on the front edge of an exposed 2x4 stud in a garage or shed and holds pencils, markers, a utility knife and other small layout tools. The saddle opening is 39.5 mm wide, sized for the 38 mm (1.5 in) face of a standard 2x4. You fix it with #8 wood screws, either through two 5 mm side holes or one hole in the back wall. The bin is 80 x 46 x 70 mm, with a 76 x 18 mm rear slot and three front cells.
Divided Wide Pegboard Bin
A four-column open-top bin for standard 1/4 in pegboard (6.35 mm holes on a 25.4 mm grid), 100.8 W x 80 D x 70 H. It is part of the '1/4 in Pegboard Locking-Peg Tool Wall' kit. It hangs on two of the kit's printed octagonal hook pegs at X ±38.1 mm and is held by two split, ridged lock pins placed 25.4 mm below the hooks. The 5 mm back plate is flat behind, and the back plate and 3.6 mm front wall carry 2.9 x 1.5 mm grooves at X = −25.4, 0 and +25.4 for the kit's 2.0 mm slide-in dividers.
Gridfinity 1x2 Twin Scoop Bin
A true-spec Gridfinity 1x2 bin — 41.5 x 83.5 mm footprint on the 42 mm grid, 28 mm tall (4 height units) — with the full three-step foot profile (35.6 / 37.2 / 41.5 mm) so it drops into any standard baseplate, and a matching stacking lip on top. Inside it is split into two 18.3 mm lanes, each with a 45 degree scoop ramp at the front so M3 screws, nuts and standoffs sweep straight out into your fingers.
Pegboard Two-Bin Tool Caddy
A 100 x 66 x 50 mm two-compartment caddy that hangs on standard 1/4 in pegboard (1 in / 25.4 mm hole grid) using four printed hex pegs with up-turned locking tips, so it cannot pop off when you grab a tool. The deep rear bin (95 x 34 x 44 mm) takes pliers, snips and markers while the 13 mm front trough sorts bits and small screws; a sloped front scoop gives finger access, and two M4 clearance holes on reinforced bosses let you screw it straight to a wall or French cleat instead.
Dovetail-Link Drawer Bin
A 100 x 62 x 38 mm open-front parts bin with a vertical dovetail rail on one side and a matching undercut socket on the other, so bins slide together into a row that can't shuffle around in a drawer (116 mm link pitch). The recessed 56 x 8 mm label panel takes a strip of tape, the 28 mm finger scallop lets you reach in, and two M3 clearance bosses (3.4 mm through, 6.6 mm counterbore) let you screw a bin down to a shelf or cleat board instead.