Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1 in Wire Shelf Post Split Sleeve Pair
Replacement wedge-collar sleeve pair for 1 in (25.4 mm) wire-shelving posts (Metro, HDX, Whalen/Costco, Seville style), printed upright and joined by two snap-off tabs. Bore is 25.6 mm with a 2.6 mm wide, 0.8 mm deep internal rib 15 mm above the base that drops into the post groove; the outer taper runs 28.8 mm at the small end to 34 mm at the top over 46 mm, so any shelf collar whose bottom opening passes 28.8 mm wedges and locks as it slides down. Print one pair per post position (four pairs per shelf) to re-hang a shelf whose original clips cracked or went missing.
Three-Cell Draining Cutlery Caddy
This is a freestanding cutlery basket to replace the one that cracked or went missing from a dish rack. It measures 100 x 70 x 100 mm and has three 31 mm cells for forks, knives and spoons. Water drains through 5 mm holes in the floor into four underfloor channels that open out both sides, and vertical slots in the front and back walls let air through so the cutlery dries instead of sitting in a puddle.