Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Notched Drawer Divider
A 55.2 × 36 × 3 mm snap-in divider for the 'Dovetail-Stacking Parts Drawer Cabinet' kit. It drops into the 3.8 mm rib slots at 30, 60 or 90 mm inside the Detent-Stop Parts Drawer. That fits the 70 × 50 × 130 mm Dovetail Drawer Cell Housing drawer and splits it into 2, 3 or 4 compartments. A 24 × 4.5 mm bottom notch straddles the drawer's 23 mm spine, and a 20 × 6 mm finger scallop lets you lift it out. 0.5 mm chamfers on the side edges help it into the slots. It takes no fasteners.
Print-In-Place Hinged Eight-Bay Parts Case
A pocket case for small parts, 100 x 64 mm and 22.4 mm tall when closed. It has eight bays of about 22 x 29 x 16 mm, sized for screws, nuts, crimp terminals or the spare clips from a repair job. The lid prints lying flat next to the box on a 4 mm pin hinge that comes off the bed already assembled. A locating rim under the lid drops into the box mouth, sits 0.5 mm clear of the dividers so bays stay separate, and a front tab lifts it open.
12 mm Vial Stepped Rack With Pour Tray
A two-tier rack that holds twelve 12 mm OD screw-cap vials or small test tubes upright, one size of loose M2/M2.5 screws, washers or 0402/0603 passives per tube. The back row stands 12 mm taller so you can read the labels. The 12.8 mm bores have chamfered lead-ins, and a 26 x 100 mm pour tray in front lets you tip out a tube, pick what you need and pour the rest back. The rack is 104 x 74 x 36 mm and the sleeves are hollow to keep material low.
Dovetail-Link Drawer Bin
A 100 x 62 x 38 mm open-front parts bin with a vertical dovetail rail on one side and a matching undercut socket on the other, so bins slide together into a row that can't shuffle around in a drawer (116 mm link pitch). The recessed 56 x 8 mm label panel takes a strip of tape, the 28 mm finger scallop lets you reach in, and two M3 clearance bosses (3.4 mm through, 6.6 mm counterbore) let you screw a bin down to a shelf or cleat board instead.