Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Stand Mixer Attachment Wall Hook Rack
A 150 x 62 mm wall or cabinet-door rack with three rising 12 mm hook fins that hang a stand mixer's flat beater, whisk and dough hook by their open frames, with an 8 mm lip that keeps them from sliding off. It mounts with two #8 wood screws (4.8 mm clearance holes, 50 mm apart). It prints upright with the fins doubling as feet, so the hook arms take load inside the layers.
Vertical Bike Wall Hook With Rim Saddle
Screw-on J-hook that hangs a bike vertically by its front wheel. The rim's spoke bed rests in a curved saddle 85 mm out from the wall, behind a lip 24 mm tall. It mounts to a stud with two #10 (4.8 mm) or M5 screws through countersunk 5.5 mm holes 105 mm apart. The part is 104 x 140 x 22 mm and prints on its side, so the bending load runs along the layers instead of across them.
Screw-On Ladder Rail Wall Hook
A heavy wall hook for hanging a ladder flat on the garage wall. It has a 92 mm deep cradle and a 32 mm retaining lip, so the side rail of a stepladder or a nested extension ladder drops in and can't roll out. Print two and fix each to a stud with #10 (4.8 mm) screws through 5.5 mm holes. It prints on its side, 150 x 112 x 22 mm, so the weight loads along the layers and the tapered truss arm keeps the plastic volume down.