Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Trailer Louvered Wall Vent Cover
A replacement exterior louvered vent for fiberglass travel trailers and campers whose OEM louvered vents are no longer made. It has a 130 x 100 mm flange around a 100 x 70 mm opening, with 45° rain-shedding slats on a 12 mm hood. Four 4.6 x 10.6 mm slots take #8 screws, so it can pick up most existing hole patterns.
Notched RV Roof Vent Prop Stay
A replacement prop arm for manual caravan/RV roof vents and hatch lids. It's a 168 mm long, 18 mm wide, 7 mm thick bar with a bossed 5.5 mm M5 pivot hole at one end. At the other end is a 90 mm slot with six notches 16 mm apart, so the stud on the lid can rest at six different opening heights. The slot lets it fit lids whose stud sits anywhere along that range, so you don't need the discontinued dealer part.
Pinch-Clamp RV Dump Valve T-Handle
A replacement T-handle for RV black and grey tank dump valves with an 8 mm stem. It clamps onto the stem with one M4 pinch bolt and a captured M4 nut, so you don't need a pin or set screw. The 110 x 58 x 16 mm grip lies flat on the printer bed so the pulling force runs along the layers, and it has finger scallops and lanyard slots. The 8.3 mm bore is 17 mm deep, with a 4 mm solid entry collar ahead of the split jaw.
RV Bay Door Snap Hold-Open Catch
A two-piece snap catch that holds an RV or trailer storage bay door open in the wind. A 9.6 mm knob on the door stud snaps through an 8.2 mm flexing fork mouth on the wall catch. Both parts are 60 x 20 mm mounting bars with two 4.6 mm holes on 44 mm centres, for #8 wood screws or M4 bolts and nuts. It prints already snapped together.
Cellular Grid RV Stabilizer Jack Pad
This 130 x 130 mm pad goes under the small OEM foot of a scissor or screw stabilizer jack on an RV or trailer, so the foot doesn't sink into gravel or soft ground. Any foot up to 120 mm across sits inside the lipped tray. The open 21.7 mm grid cells underneath (8 mm deep) fill with soil and lock the pad in place. Drain notches let rain run out, and a pull tab with a 20 mm finger hole lets you slide it back out from under the jack.