Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pop-Up Canopy Mid Truss Pivot Connector
In-line connector that joins two halves of a pop-up canopy truss bar and carries the M5 pivot bolt for the crossing bar, replacing the cracked plastic X-pivot on Ozark Trail, E-Z UP and ABC style frames. Twin 32 mm deep sockets fit 25 x 13 mm rectangular truss tube (13.4 x 25.4 mm bore, 3 mm walls), a 5.5 mm pivot hole runs through the solid 26 mm center block with a captured M5 nut pocket on the back face, and 5.5 mm cross holes 15 mm from each mouth take the original rivets or M5 bolts; 90 x 19.4 x 31.4 mm overall. Measure your tube before ordering.
Pop-Up Canopy Leg V-Jaw Stop Collar
This is a two-jaw clamp-on stop collar that replaces the snapped push-button lock on a pop-up canopy or gazebo leg. Two 90° V-jaws (70 x 20 x 25 mm each) close on any square or round inner leg from 19 to 32 mm across using two M5 bolts (60–70 mm) and nylock nuts, which sit in hex pockets. The outer leg sleeve then rests on the flat top of the collar. Both jaws print as one piece on snap-off tabs.
Canopy Leg V-Block Guy-Line Anchor
A 90° V-block that straps to a pop-up canopy or gazebo leg with a worm-drive hose clamp or strap through its two 14 x 3.5 mm band tunnels. It adds a ribbed tab with a 10 mm hole for a guy line or sandbag, so wind load goes to the ground and not into the plastic corner joints that tend to snap. The V seats round legs from 19 to 32 mm and 25 mm square legs set corner-in. The block is 56 mm tall and 36 mm wide, and the tab reaches 67 mm.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.