Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi Zero Outdoor Sensor Node Gland Box
A wall-mount base tub for outdoor Home Assistant and garden sensor nodes. It measures 90 x 60 x 36 mm and has a 3 mm wall. Inside are Pi Zero standoffs on the 58 x 23 mm pattern with 2.9 mm M2.5 holes, counterbored from the back. Two 12.6 mm holes in the bottom wall take M12 or PG7 cable glands, so sensor leads come in from below and water runs away from them. There are four M3 heat-set insert bosses with 4.0 mm bores for the lid, a 3 mm flat rim for foam gasket tape, and slotted wall ears for #8 screws.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
Mast Pipe Enclosure Saddle Clamp
A 72 x 80 mm mounting plate with two 90-degree V-jaw ribs spaced 50 mm apart that cradle a 20–48 mm OD mast pipe (3/4 in to 1-1/2 in conduit or fence rail) and pull it in with two standard 12.7 mm stainless worm-drive hose clamps threaded through the moulded band tunnels. The V-groove plus the 50 mm rib spacing stops the wind-twist you get from U-bolts alone; the plate carries four M4 clearance holes on a 56 x 40 mm pattern for a junction box or printed LoRa/solar node enclosure and an 18 mm centre pass-through for a cable gland or drainage.