Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
608 Bearing Clothesline Pulley Wheel
A 70 mm replacement pulley wheel for old clothesline brackets whose original wheel has seized or cracked. The bracket stays where it is. A 608 bearing (8 x 22 x 7 mm) press-fits into a 22.05 mm pocket and runs on an 8 mm (M8 or 5/16 in) axle bolt. The wheel is 15 mm thick at the hub, so it fits any fork with at least 16 mm between the cheeks; washers take up any extra width. The 90° V-groove, 5 mm deep, holds clothesline up to about 6 mm thick.
Print-In-Place Rope Turning Block
A surface-mount rope pulley with a 34 mm sheave that prints in place on its own 9 mm axle post — no bearings, no assembly. The V-groove takes 5–6 mm rope (clothesline, tarp ridgeline, ceiling hoist, kayak or gate pull line) and redirects it up to 180°; the 50 x 58 mm base screws down with four M5 / #10 wood screws through 5.5 mm holes, and the capture cap keeps the rope in the groove even when the line goes slack.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.