Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Robot Mower Wire Peg Setter Head
A push head that turns a length of 1/2 in Sch 40 PVC pipe (21.3 mm OD) into a stand-up tool for pressing robot-mower boundary-wire pegs into the lawn. A 5 mm channel underneath keeps the wire centred and a 14 mm cross slot seats the peg head, so you can set pegs without kneeling or bending them. The 70 x 46 mm foot has a 42 mm deep socket (21.8 mm bore), and an M4 / #8 cross bolt locks the pipe in place.
5/8-11 RTK Antenna Mower Riser
A 53 mm tall pedestal that raises a 5/8"-11 RTK GNSS antenna (the Ardusimple and u-blox survey types) above a robot mower or homebuilt rover shell. It is not tied to one chassis model: a 90 x 60 mm base has four M4 slots that fit hole spacings from 54 to 78 mm by 40 mm. A 5/8" bolt goes up through a 16.8 mm hole in a 60 mm antenna deck. Its 15/16" hex head sits in a 25 mm-wide open tunnel whose walls stop it turning while you spin the antenna on, and a 20 mm port in the floor lets the coax drop into the chassis.