Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Strap-On Pool Ladder Step Grip Tread
Strap-on anti-slip tread for above-ground pool ladder steps and deck steps. The pad is 150 x 120 mm with ribs across the step and 72 drain slots. Two pairs of 12 x 3.5 mm slots take heavy zip ties or UV-rated straps around steps up to about 100 mm deep, and the straps sit in recessed channels where feet won't wear them.
Drip Line Twin-Lane Zip-Tie Ground Stake
This 150 mm garden stake has two V-lanes in its head. The wide lane takes drip mainline about 12–20 mm OD, and the narrow lane takes small feeder tubing about 5–8 mm OD. A zip tie up to 5 mm wide goes through a channel under both lanes, wraps over the tubing and locks the line down so it can't blow out or get pulled up. It prints flat with a T-ribbed spike, so the bending load runs along the layers instead of across them, and it's stiffer than the bagged stakes that snap.
Solar Path Light Rescue Stake
A replacement ground stake for solar path lights that snapped at the thin stake joint. The 170 mm stake has a T-ribbed spike and a 90° V-cradle on top that holds any light pole from 12 to 25 mm in diameter, fixed with two zip ties through bridged slots. It prints flat so the spike's layer lines run along its length, which stops it snapping at the ground line.
Twin-Band Downspout Wall Standoff
This is a wall-mounted standoff block for a gutter downspout. It measures 130 x 60 x 11 mm and screws on with two #10 or M5 screws (5.5 mm countersunk holes). Two 14 x 3.5 mm tunnels run through it for zip ties or 1/2 in (12.7 mm) worm-drive hose-clamp bands. The band wraps around the downspout, so one part fits 2x3 in (about 51 x 76 mm nominal), 3x4 in or any other profile, and it replaces the brittle vinyl straps that snap every winter.
Snowblower Chute Crank Rod Guide
This replaces the snapped eyelet that holds a snowblower's chute-rotation crank rod against the handle. A 90° V-saddle sits on any 19–32 mm handle tube and is held by two zip ties (up to 5 mm wide) that run through tunnels in the saddle. The 14 mm guide eye takes crank rods up to 12 mm, about 38 mm from the tube. Overall size is 40 x 66 x 24 mm. Print it in PETG for winter use.