Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Toilet Seat Hinge With 5 mm Steel Pin
Replacement hinge for a wooden or MDF toilet seat whose stock hinge snapped: a 50 x 22 mm seat leaf with four counterbored #8 wood-screw holes (4.5 mm) and a 20 mm knuckle, plus a 40 x 30 mm bowl post with a 9 x 14 mm slot for the 5/16 in, M8 or M6 seat bolt and two 7 mm ears that put the pivot 20 mm above the bowl. A 35 mm length of 5 mm steel rod is the pin: it presses into the knuckle (5.1 mm bore) and turns in the 5.3 mm ear bores, so the printed plastic never acts as the axle. Both pieces print flat on one sprue; snap it off, print one set per side, and order it in PETG for a hinge that outlasts PLA.
Framed Shower Door Bottom Pivot Block
Replacement bottom pivot block for framed pivot shower doors whose nylon original has cracked and been discontinued. The tongue slides into the aluminium stile channel (default 22 x 12 mm, set at the top of the script), a 30 x 14 mm shoulder stops on the stile end and carries the door weight, and a 14 mm pin block below takes a 5 mm steel rod in a 5.3 mm bore held by an M3 set screw, with the pin offset from the channel centre adjustable (default 6 mm). Two 3.4 mm M4 self-tap holes through the tongue let the original frame screw go through either the face or the side of the stile; overall 49 mm long.