Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
3/4 in EMT Clamp-On Gate Hinge Knuckle
A clamp-on hinge knuckle for 3/4 in EMT conduit (23.4 mm OD) that turns conduit frames into swinging gates, fence panels and cabinet doors. Print two or more: clamp one on the post and one on the gate, then stack the 20 mm knuckles on an 8 mm steel rod or M8 bolt pin through the 8.3 mm bore. Each one tightens with a single M5 pinch bolt and nut, and the frames sit on 32 mm centres.
Fridge Door Hinge Pin Socket Plate
A screw-on repair plate that gives a sagging refrigerator or freezer door a fresh hinge-pin socket when the moulded nylon pocket has worn oval. The 72 x 52 x 5 mm plate carries a ribbed 22 mm boss with an 8.3 mm slip-fit socket 12 mm deep for a standard 8 mm hinge pin, a 22 mm x 2 mm relief recess underneath so it sits flat over the chewed-up original boss, and four 4.5 mm holes on a 56 x 38 mm pattern for #8 screws or M4 bolts.
Gate Opener Post Pivot Bracket
A chunky replacement post-pivot bracket for a swing-gate opener arm: an 88 x 48 mm backplate that covers the full 3.5 in face of a 4x4 wood or vinyl post, four 5.5 mm holes (M5 / #10 lag screws) on a 56 x 24 mm pattern, and a 18 mm thick tongue with an 8.3 mm vertical bore for an 8 mm / M8 pivot pin 24 mm off the post face. Printed on its back so every layer line runs across the pull direction, with twin 45 degree webs tying the tongue into the plate — it replaces the cast aluminium bracket that snaps or strips out of a Mighty Mule / Ghost Controls style kit.
Linear Actuator Swivel Clevis Mount
A print-in-place two-axis end mount for 12 V linear actuators: a 64 x 56 mm base flange with four M5 clearance holes carries a captured swivel yoke that yaws a full 360° on a printed post, while a 22 mm wide clevis with an 8.5 mm cross bore takes the actuator's own 8 mm rod-end pin 19 mm above the mounting face. It replaces the brand-specific bracket-and-pin kits that cost as much as the actuator, and the free yaw axis stops cheap actuators from binding on vent flaps, coop doors, gates and solar trackers. Overall 64 x 56 x 36 mm; the yoke and base print as one piece with 0.4–0.5 mm running clearance and cannot be pulled apart.