Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
GNSS Puck Ground-Plane 8 mm Mast Mount
An 80 mm disc that holds a GPS/GNSS module flat and up off your chassis on an 8 mm steel rod or carbon tube. The face is flat so you can stick copper tape on it as a ground plane. Strap slots in both directions take a hook-and-loop strap or a zip tie around square modules (the 22.6 mm spacing fits about 20–40 mm wide), and a 30 mm socket with ribs grips the mast with an M3 grub screw in a brass heat-set insert.
5/8-11 RTK Antenna Mower Riser
A 53 mm tall pedestal that raises a 5/8"-11 RTK GNSS antenna (the Ardusimple and u-blox survey types) above a robot mower or homebuilt rover shell. It is not tied to one chassis model: a 90 x 60 mm base has four M4 slots that fit hole spacings from 54 to 78 mm by 40 mm. A 5/8" bolt goes up through a 16.8 mm hole in a 60 mm antenna deck. Its 15/16" hex head sits in a 25 mm-wide open tunnel whose walls stop it turning while you spin the antenna on, and a 20 mm port in the floor lets the coax drop into the chassis.