Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Box Fan Anti-Tip Outrigger Corner Foot
This corner shoe replaces the snap-in feet that break off cheap 20 in box fans. The fan's bottom corner sits in a 56 x 55 mm floor with a 45 mm side wall and a 30 mm front lip. A 25 mm gusseted outrigger widens the stance so the fan is harder to tip over. Two pairs of 2.5 x 7 mm slots let a standard 4.8 mm zip tie go through the front grille, and a 3.8 mm horizontal slot takes an optional #6 screw into the housing. Print two as modelled and two mirrored in the slicer for all four corners.
Screw-Lock 5 mm Shelf Support Pin Set
A snap-off sprue of four gusseted L-bracket shelf supports for kitchen cabinets with standard 5 mm shelf-pin holes. Each one has a 9 mm octagonal pin measuring 4.6 mm across the flats and 5 mm across the corners, plus an 18 x 10 mm shelf seat with a 4 mm through-hole: drive a #6 (3.5 mm) screw up into the shelf so it can't tip or slide off. The pieces print flat, so shelf load goes along the layers, not across them.
Slotted Furniture Anti-Tip Strap Anchor
A 90 x 34 mm furniture anti-tip anchor with one 50 mm slot and a 9.5 mm counterbore. Two #8 or #10 wood screws (4.2/4.8 mm) go in at any spacing up to about 45 mm, so it lines up with holes already in a dresser or bookcase back. The 25 mm webbing strap passes through a 26 x 4.5 mm slot and pulls along the plate, not across the layer lines. Print two: one for the furniture and one for the wall stud.