Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Flex-Bow Gate Closing Bumper For 4x4 Post
This screw-on gate stop goes on a 4x4 fence post (89 mm face). It is 70 mm wide, 70 mm tall and stands 37 mm off the post. Its front is a sprung bow leaf with 6 mm of travel, so the gate stops softly in line with the latch instead of slamming and loosening the hardware. It mounts with two #10 (4.8 mm) or M5 screws through 5.5 mm counterbored holes, and its hollow body is open at both ends so rainwater drains through.
Standing Desk Keypad Knee Bumper Bar
This U-shaped bar screws to the underside of a desk and hangs below a sit-stand desk's up/down keypad, so a knee or chair arm hits the bar before it can press the buttons and move the desk. It fits keypads up to 140 mm wide and 38 mm deep. The fingers still reach in from the front, and the 5.0 mm slotted holes in the two flanges take #8 or #10 wood screws with 8 mm of front-to-back adjustment. Overall size is 176 x 52 x 28 mm, and it prints flat so the knee load stays in the layer plane.
Toilet Tank Lid Spring-Arch Bumper Clips
A set of four push-on bumper clips. Each one straddles the top edge of a ceramic toilet tank wall and holds it with flexing fins, so one clip fits any wall from about 8 to 13 mm thick. A sprung 2 mm arch on top cushions the lid and stops it rattling and chipping. Each clip is 20 mm wide, 21 mm tall and 12 mm long. The inner leg is only 2 mm thick, so it slides in beside the lid's skirt. The four clips print flat on one sprue strip 98 mm long; snap them off and push one onto each corner.
Rover Sensor Bumper Plate
An L-bracket front bumper for the 'N20 4WD Skid-Steer Rover Base' kit. Its 16 x 60 x 4 mm base bolts to the chassis plate at (68, ±15) with M3x12 screws and nuts, sitting in 6 mm counterbores. The 60 x 40 x 4 mm face wall has a 5 x 3 grid of 3.4 mm M3 holes on a 10 mm pitch for mounting sensors, and two 3 x 8 mm zip-tie slots. It prints on its side so bumper impacts load along the layers, not across them.
Toilet Seat Bumper Riser Set
A snap-apart set of four replacement toilet-seat buffers in 10, 12, 14 and 16 mm heights (20 mm flange, 14 mm register spigot), each with a blind 3.4 mm bore that takes the original seat screw or an M4 self-tapper. Replaces perished rubber bumpers that make the seat rock and slam — pick the height that closes the gap to the porcelain, snip it off the runner and screw it on; edge notches count the size (1 notch = 10 mm, 4 notches = 16 mm).