Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Office Chair Caster Stem Glide Foot
Fixed glide foot that drops into an office chair base in place of a rolling caster, for the standard 7/16 in x 7/8 in (11 x 22 mm) grip-ring stem socket; the 10.2 mm stem carries four crush ribs to 11.4 mm so it presses tight into 11.0–11.3 mm sockets (not 10 mm Euro stems). The 50 mm diameter, 14 mm tall pocketed foot has a flat bottom for a stick-on felt pad and a 36 mm overall height; print five to stop a chair rolling on hard floors.
Print-In-Place 60 mm V-Race Caster Wheel
This 60 mm OD x 20 mm wide replacement caster wheel prints in place, with the tire spinning around a separate captive hub on a 45° V-ridge race. It suits office chairs, rolling coolers, carts and luggage. The hub has an 8.3 mm bore, so it slips onto the original 8 mm steel axle pin. The hub's raised 16 mm boss acts as a fork spacer. Wear lands on the large 34 mm race instead of chewing out a small axle bore.
Office Chair Caster Socket Repair Sleeve
This sleeve repairs a cracked caster socket on an office chair base. Drill the split socket out to 16 mm (5/8 in), then epoxy the sleeve in place. The 11.2 mm bore takes the common 11 x 22 mm grip-ring caster stem, and the 28 mm tube is longer than that stem. A 32 mm washer flange spreads the load across the underside of the leg. Three V-grooves hold the epoxy.
Chest Freezer Corner Caster Cradle
This corner cradle is 90 x 90 mm with 5 mm walls 28 mm tall. It lets you put a chest freezer, big cooler or tool chest on wheels without drilling into the cabinet. Each corner drops into a cradle, and a square-plate swivel caster bolts to the flat 10 mm underside. Four diagonal 8.6 mm slots take M8 or 5/16 in bolts on any square hole pattern from about 40 to 59 mm. 18 mm-wide pockets, 5 mm deep, keep the nuts and washers below the top face.
Office Chair Caster Parking Cup
This is an 80 mm dished floor cup that stops an office chair caster from rolling. It holds single or twin-wheel casters from 50 to 65 mm across and up to 26 mm wide in a 9 mm-deep bowl, so the chair stays put on hard floors at a desk or standing desk and the floor doesn't get scuffed. The body is 12 mm tall, the floor is 3 mm thick, and the rim is flat and sloped so a wheel rolls in with a nudge but won't roll out by itself.
608 Bearing Swivel Caster Mount
Print-in-place swivel caster for differential-drive robot chassis: the fork prints already captured on the base plate's retaining post and spins 360 degrees, so the third wheel stops scrubbing in turns. A standard 608 bearing (22 x 7 mm) drops between the 8 mm-spaced legs on an 8 mm rod or M8 bolt axle as the hard roller; the 46 x 40 x 5 mm plate bolts up with four M3 clearance holes on a 32 x 28 mm pattern, giving ~39 mm ride height and 21 mm of trail for self-centering.