Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
8 mm Shaft Ortho-Planar Flexure Spring
A one-piece ortho-planar flexure spring. Three folded 2 mm arms let the hub move along the axis while it stays parallel and centred. The 8.3 mm bore slides onto an 8 mm rod or shaft, and the 70 mm outer ring bolts down through three M3 clearance holes. Use it to preload a 608 bearing stack, push a sliding collar back, or replace a wave washer you don't have.
Print-In-Place Flexure Cord Lock
This print-in-place cord lock replaces the spring barrel stopper that rusts or snaps on jackets, bags and tent lines, and it works with 2–3 mm cord. Pressing the 4 mm button lines up the 3.6 mm cord holes. When you let go, two 13.5 mm printed leaf springs push the slider back so the holes sit 2.6 mm off-centre and pinch the cord. There is no metal spring to corrode. The frame is 26 x 40 x 8 mm and has 0.5 mm clearance on all sides. PETG gives the springs the longest life.
Compliant Spring-Bolt Sash Tilt Latch
This one-piece surface-mount latch replaces cracked tilt latches on vinyl single- and double-hung sashes, and it also works as a spring catch for gates and cabinets. A 10 mm ramped bolt sticks out 5 mm and pulls back 6.5 mm by its thumb tab. A printed serpentine spring with nine 1.2 mm beams pushes it back out, so there is no metal spring to source. The 68 x 31 x 8.4 mm housing mounts with two 4.5 mm holes for #6/#8 pan-head screws or M4.