Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Acoustic Guitar Restringing Bench Tray
A 150 x 80 x 16 mm restringing tray for acoustic guitars. It has six bridge-pin wells (10 mm bore, 11.6 mm deep) set out left to right in bridge order, and the low-E well is hex-shaped so you can't mix up the order. Behind the wells are a 97 x 53 mm bay for the string winder and cutters, a bin for clipped string ends and ball ends, and two slots that hold picks upright. Your pins stay in sequence and the sharp offcuts stay out of the case.
Strap Button Dowel Repair Drill Guide
A hand-held guide block (80 x 32 x 24 mm) for fixing a stripped guitar or ukulele strap-button hole. Its three vertical bores share the same sight notches, so the bit stays on the original centre at every step: drill out with the 6.3 or 8.3 mm bore, glue in a 6 or 8 mm hardwood dowel, then drill a new screw pilot through the 3.4 mm bore with a 3 mm bit. Grooves under each bore clear chips, and countersunk lead-ins make it easy to start the bit.
M5 Screw Flexure-Pad Guitar Capo
A one-piece screw capo. An M5 bolt runs through a captive nut and presses on a pad hung from a 12 mm living hinge, so the bolt tip never touches the neck finish. The pad tilts up to clamp necks about 16–25 mm deep (fretboard plus neck) inside a 68 mm wide throat. The frame prints flat, so the clamping load runs along the layers, and a 2 mm recess on the bar takes a 10 mm wide rubber or felt strip that sits on the strings.
Pedalboard Six-Lane Patch Cable Raceway
This low-profile raceway clip screws to a pedalboard slat and holds up to six patch cables. Cables 5–7 mm across press through a 5 mm mouth into 7.5 mm lanes and stay put. The clip is 90 x 20 mm and only 13.5 mm tall, so it fits under most pedal overhangs. Two 4.5 mm holes take #6/#8 wood screws or M4 bolts, and the flat base also takes hook-and-loop tape.
French Cleat Guitar Neck Yoke Hanger
A guitar or bass wall hanger that drops onto a standard 45° French cleat. It has two 12 mm tines with a 50 mm gap for the neck just below the headstock, a 96 mm reach so the tuners clear the wall, raised tips that stop the instrument sliding off, and a 4.8 mm hole for an optional #8 screw that stops the hanger lifting off the cleat. It prints on its side, so the guitar's weight bends the arms along the printed layers instead of pulling them apart.