Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Shot-Filled Dead-Blow Mallet Head For 1 in PVC
A 90 x 44 x 44 mm dead-blow mallet head with a 33.8 mm blind socket that takes a 1 in Schedule 40 PVC handle (33.4 mm OD), pinned with an M5 cross-bolt. Two sealed 45°-roofed chambers either side of the socket are filled with steel shot or sand through 8.2 mm ports, which you then plug with glued 8 mm dowel. The result is a non-marring, no-bounce mallet for knocking joints together, seating panels and tapping parts into place.
Three-Size Hammer And Mallet Wall Rack
A 164 x 95 mm wall shelf with three closed drop-through slots (28x40, 32x46 and 38x52 mm). Each hammer or mallet hangs handle-down with its head resting on the shelf, and the slots sit 60 mm out from the wall so a 110–120 mm claw head clears it. It screws to a stud or anchors through three 4.5 mm holes sized for #8 (4.2 mm) or M4 screws. It prints with the shelf flat and the gussets pointing up, then mounts flipped so the gussets brace underneath.
Three-Slot Nail And Brad Finger Saver
A flat 125 mm paddle with three tapered slots that hold nails upright while you hammer, so your fingers stay out of the way. The slots cover shanks from 1.2 to 2.4 mm (brads and panel pins), 2.2 to 3.6 mm (finish and wire nails) and 3.4 to 5.0 mm (tacks and large nails). The 4 mm fork is thin enough for short brads, and a ribbed 18 mm handle with an 8 mm hang hole keeps it stiff.