Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Dovetail Screw-Jaw Connector Pinning Vise
This bench vise holds JST-XH, JST-PH and Dupont connector housings square while you push crimped pins in. It has a 42 mm wide sliding jaw that prints in place in a 45° dovetail with 0.5 mm clearance, and one M3 x 25–30 screw with a captured hex nut pushes it closed. The jaw opening runs from 0 to 16 mm, so it doesn't rely on any one housing size. Housings up to 40 mm long sit face-down on the bench between the jaws.
JST-XH Balance Lead Parking Tray
This 112 x 90 x 22 mm tray has five lanes for 2S–6S LiPo JST-XH balance leads. The lanes are 16, 18, 20, 22 and 24 mm wide, and raised dots on the floor show the cell count. Each lane has a cross wall with a 2.4 mm slot. The flat lead ribbon drops into the slot, but the plug housing can't pass through it, so plugs stay parked at the back and the leads coil in the 64 mm front bay without tangling or getting crushed.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.