Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Joist-Mount M8 Hoist Pulley Fork Bracket
A ceiling-joist fork bracket for DIY bike, kayak and ladder hoists. It holds any rope sheave up to 22 mm thick and 80 mm in diameter (for example a 608-hub pulley) on an M8 bolt through 8.3 mm bores, so you don't have to buy a full hoist kit just for the pulley block. The four 5.5 mm holes take #10 (4.8 mm) wood screws into the joist. The part prints on its side, so the downward rope pull runs along the layers instead of across them.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Edge-Printed 8 mm Pin Gate Strap Hinge
A heavy-duty strap hinge for wood gates, 170 mm across (120 mm strap, 50 mm post leaf) and 40 mm wide, with 6 mm thick leaves. It's printed on its edge so gate sag pulls along the layer lines, not across them. The two leaves print already interlocked on five 18 mm knuckles with 0.5 mm clearance. Afterwards you drop an 8 mm steel pin or an M8 x 50 bolt through the 8.3 mm bore. The strap takes 6 staggered #10 screws (5.3 mm holes) and the post leaf takes 4, which spreads the load better than the tin hinges that sag in one season.