Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Shot-Filled Dead-Blow Mallet Head For 1 in PVC
A 90 x 44 x 44 mm dead-blow mallet head with a 33.8 mm blind socket that takes a 1 in Schedule 40 PVC handle (33.4 mm OD), pinned with an M5 cross-bolt. Two sealed 45°-roofed chambers either side of the socket are filled with steel shot or sand through 8.2 mm ports, which you then plug with glued 8 mm dowel. The result is a non-marring, no-bounce mallet for knocking joints together, seating panels and tapping parts into place.
Three-Size Hammer And Mallet Wall Rack
A 164 x 95 mm wall shelf with three closed drop-through slots (28x40, 32x46 and 38x52 mm). Each hammer or mallet hangs handle-down with its head resting on the shelf, and the slots sit 60 mm out from the wall so a 110–120 mm claw head clears it. It screws to a stud or anchors through three 4.5 mm holes sized for #8 (4.2 mm) or M4 screws. It prints with the shelf flat and the gussets pointing up, then mounts flipped so the gussets brace underneath.