Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
90/45 Chisel Paring Guide Block
A 100 mm long, hollow-ribbed guide block for paring with a chisel. Clamp it on the work and run the chisel's flat back down the dead-flat 90° face to trim tenon shoulders and dovetail baselines square, or down the 45° face to clean up mitres and chamfers. The profile is 60 x 40 mm, and the block is printed on its end so both guide faces come out as smooth, accurate perimeter walls with sharp reference edges.
Picture Frame Band Clamp Corner Block
This corner block is for strap or band clamps when you glue up mitred picture frames and boxes. Print four. Each block has a pair of 90° jaws, 40 mm long and 21 mm tall, that hold the frame square. A rounded R12 outer face lets the strap wrap without kinking, and a 3 mm bottom lip keeps a strap of any width from sliding off. A 3 mm leveling ledge holds all four corners in one plane, and a 6 mm through-hole at the inside corner lets glue squeeze-out drip away so the joint doesn't glue itself to the block.