Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Strap-On Pool Ladder Step Grip Tread
Strap-on anti-slip tread for above-ground pool ladder steps and deck steps. The pad is 150 x 120 mm with ribs across the step and 72 drain slots. Two pairs of 12 x 3.5 mm slots take heavy zip ties or UV-rated straps around steps up to about 100 mm deep, and the straps sit in recessed channels where feet won't wear them.
Telescoping Pool Pole Pinch-Bolt Lock Collar
Replacement lock collar for a telescoping pool, window-washing or painter's pole whose plastic twist/cam lock has cracked. The 46 mm tall split collar slides 20 mm over the end of the outer aluminium tube (default 31.5 mm OD, bore 32.3 mm) and seats against an internal 45 degree shoulder, while the inner tube (default 28.7 mm OD, bore 29.1 mm) slides through the upper section. Two M5 pinch bolts on a 20 mm wide lug straddle a 3 mm slit: the lower bolt clamps the collar permanently to the outer tube, the upper bolt is the lock you tighten to hold the pole at length. Both bolts use 5.5 mm clearance holes and an 8.3 mm across-flats captured hex nut pocket, so a wing bolt or printed star knob makes it tool-free. The two tube diameters are the first two lines of the script; measure your pole with calipers and edit them.
Pool Winter Cover Barbed Cable Cinch Clip
A 60 x 36 x 14 mm clip that replaces the cracked UV-brittle clips holding a winter pool cover to its perimeter cable. You fold the cover hem around the cable and push it into the barbed V-channel, which tapers from 10 mm down to 3 mm, so cable-and-hem bundles from about 3 to 9 mm thick lock in place. A 6 x 26 mm slot beside it takes an anchor strap, bungee hook or tie-down for straps up to 25 mm wide. The clip prints flat, so the pull on the strap stays in the layer plane.
Clamp-On Pool Skimmer Basket Handle
A replacement grab handle for pool skimmer baskets whose sun-brittle handle has snapped off. It straddles the basket rim in a 6 mm slot that takes walls up to about 5.5 mm thick. You drill through the rim and pinch it with two M4 bolts, which seat in captive-nut pockets. It has a 16 mm round grip 40 mm above the rim and an 80 mm wide finger opening. The part is 96 mm wide, and because it doesn't depend on the basket's shape it works on any brand. Print it in ASA or PETG for outdoor use.
Universal Pool Skimmer Weir Door
Trim-to-fit replacement weir door for pool skimmers, 160 x 100 x 18 mm, with a 124 x 84 mm ribbed flapper panel. The hinge rail carries 6.6 mm pivot sockets bored 31 mm deep from each end plus saw-guide notches at 144 mm and 128 mm, so one part covers three pivot spacings; behind each socket a 3.4 mm bore takes an M4 stainless self-tapping screw if your skimmer has no pins and you need to make your own pivot studs. The bottom bulb is a 12.5 mm float channel with a 45 degree self-supporting roof that takes a friction-fit strip of pool-noodle foam so the door swings shut against backflow. Print in PETG or ASA with 4 walls.